skip to main content

10% OFF WITH CODE AUTUMN10

£0.00
0
Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9
 Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9
Active holder for fixed installation for Tetra THR9

Active holder for fixed installation for Tetra THR9

With Molex adapter system. 2A charger. With tilt swivel. 12/24V.

Brodit special order product, please contact us for details

Product Code: 513952

 An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Attach onto ProClip Mounting Platform in your car.
 
With Molex adapter system. You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection). The product is E-approved. 12/24 Volt. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended.
  
Dimensions: 61 x 95 x 80 mm (W x H x D mm)
Weight: 221 g
Cable length: Total length: 346 cm (Holder to box: 150 cm, Connectors+box 14 cm, Box to open end: 156 cm.)

Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
 
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
 
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
 
4. The holder is in place.

Active holder for fixed installation for Tetra THR9 Active holder for fixed installation for Tetra THR9 Active holder for fixed installation for Tetra THR9 Active holder for fixed installation for Tetra THR9

Also Suitable for:

Item added to basket