With USB-A cable + cig-plug adapter with 2 USB-A ports: QC 3.0A + 2.4A. Charging via pogo pins. With easy-switch system. With tilt swivel. 12/24 Volt.
Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. With USB-A cable with cig-plug adapter, choose to connect either to the vehicle's USB-A outlet or the 12/24V socket. The cig-plug adapter has two USB-A ports: QC 3.0A + 2.4A. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the device into place in the holder so it connects to the pogo pin charging, and to take it out of the holder when leaving the car.
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto a ProClip mounting platform or Pedestal mount.
Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw so the holder is firmly in place, but still can be adjusted.
3. Slide the device straight downward into the holder. Press it carefully downward into place so it connects to the charging.
4. The holder is in place.
Also Suitable for:
Shop safely and securely
