With power cable, worldwide adapters included. Charging via pogo pins. Fits for devices with original skin. With tilt swivel.
This holder is equipped with a DC-Plug for charging of your device. The holder is used by haulage contractors, warehouses, schools and offices, as well as within health care, police and civil protection; everywhere where tablets are used in daily operation. The holder is mounted onto a tilt swivel. This mean you can easily adjust the angle for better viewing and switch between portrait and landscape mode simply by turning the holder into desired position. It is easy to put the device into place in the holder, and to take it with.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
2. Install the DC connector.
3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
4. The holder is in place.
Also Suitable for:
Shop safely and securely
