Adjustable holder. Fits for devices with and without original skin. With tilt swivel. 2A charging. 12/24V.
Keep your phone in an active holder and you will always have it freshly charged. Neat, discreet and convenient. For fixed installation. The holder is to be connected inside the dashboard, providing an elegant installation without any cables hanging over the interior. Adjustable holder for use with the bare device, or the device with original skin (which is included with the phone). Before using the holder you set the holder's width so it suits your device with or without skin. The holder has a neat and discreet design which blends well with the vehicle's interior. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the phone in place in the holder so it connects to the charging, and to take it out of the holder when leaving the vehicle.
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 20° and swivels 360°. Mounting plate 42x50 mm with AMPS-holes. Made of high grade ABS/Acetal plastic. Color: black. Made in Sweden. Connect the power cable with a 2A fuse. Professional installation recommended. Attach onto ProClip Mounting Platform.
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
1. To adjust the holder to fit for your device with or without skin: Loosen the screws on the front side of the holder slightly. Pull out the sides of the holder slightly. Place the device in the holder and press the sides together so the device is firmly in place. Remove the device carefully without changing the position of the sides. Tighten the screws on the front side of the holder. 2.To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 4. The holder is in place.
Also Suitable for:
Shop safely and securely
