For Apple Composite AV Cable. With tilt swivel.
Holder with connector attachment. The choice for you who often connect a connector to your device. The connector is easy to attach to the holder, and then it connectos to the device automatically when you put your device in the holder so you do not have to connect it manually each time. (Connector not included)
The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen.
Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.
An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.
Please read all of the instructions and look at the pictures before attaching the holder. The holder in the installation pictures may look slightly different from the one you have received. However, the same instructions apply.
1. Installation of cable: Place the holder with the frontside upwards. Place the connector into the holder. The mark pointing upwards, so you can see it when placing the connector into the holder. Place the lid over the connector, make sure the cable is in the correct position. Screw the lid into place by using the enclosed screws.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Tighten the screw until the holder is firmly in place, but still can be adjusted.
3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder Carefully, slide the device sideways into the holder so you hear/feel it snaps into place. To remove the device from the holder: Slide it to the left then press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
4. The holder is in place in upright, horizontal position.
Also Suitable for:
Shop safely and securely
