skip to main content

Brodit 2 part solution

Home > Car Phone Holder > Samsung > Galaxy Xcover 5 > Holders > Active holder for fixed installation

Active holder for fixed installation view larger image

Active holder for fixed installation for Samsung Galaxy Xcover 5

With USB-A cable. 2 USB-A ports: QC 3.0A + 2.4A. With tilt swivel. 12/24 Volt. Charging via pogo pins. With easy-switch system.

For Samsung Galaxy Xcover 5 in all countries. (Item # 727243)

£99.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

A bulk discount could be offered on any business order of 25+ pieces. For more details contact us.

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! You can choose to use the holder as an active holder for charging of your device only, or to connect an USB cable for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection). 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. Professional installation recommended.

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17 and swivels 360. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto a ProClip mounting platform or Pedestal mount.

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.


Also Suitable for:
For Samsung Galaxy Xcover 5 in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw so the holder is firmly in place, but still can be adjusted.

3. Slide the device straight downward into the holder. Press it carefully downward into place so it connects to the charging.

4. The holder is in place.

Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation