skip to main content

Brodit 2 part solution

Home > Brodit Step 1 > Samsung > Galaxy Tab Active Pro T540/T545/T547/T547U > Holders > Holder for Locking

Holder for Locking view larger image

Holder for Locking for Samsung Galaxy Tab Active Pro T540/T545/T547/T547U

Active holder with cig-plug. With spring stud locking. Fits for devices with original skin.

For Samsung Galaxy Tab Active Pro T540/T545/T547/T547U in all countries. (Item # 746148)

£99.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

A bulk discount could be offered on any business order of 25+ pieces. For more details contact us.

This holder is to be used when you want to have your Tab Active Pro extra securely in place and still have it easy accessable.

The active holder guarantees a newly charged battery at all times. 2 A charging. Charging via pogo plug. The holder is equipped with a spring stud locking device. The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position.

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

Tablets (Surfpads) should not be installed onto a carís dashboard if they block the view or block key controls. ProClip (Broditís vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the carís dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicleís dashboard is always done on the customerís own responsibility. Brodit recommends to use tablets on the carís headrest, installed onto a Brodit headrest mount.


Also Suitable for:
For Samsung Galaxy Tab Active Pro T540/T545/T547/T547U in all countries.


Installation Instructions

Please read all of the instructions and †look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Press the spring stud locking upward. Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. Press the spring stud locking downward.

3. To remove the device from the holder: Press the spring stud locking upward. Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.

Holder for Locking Holder for Locking Holder for Locking Holder for Locking