skip to main content

Brodit 2 part solution

Home > Brodit Step 1 > Kyocera > DuraTR E4750 > Holders > Active holder with cig-plug

Active holder with cig-plug view larger image

Active holder with cig-plug for Kyocera DuraTR E4750

With 3-point hold and hidden charging pins. With tilt swivel.

For Kyocera DuraTR E4750 in all countries. (Item # 712104)

Brodit special order product, please contact us for details.

Extra robust holder, designed to withstand rough working conditions in everyday professional use. Customized holder with a very secure hold and unimpaired charging thanks to the 3-point hold feature. Soft connection to the charging pins which are hidden for protection from frequent wear and breakage. Easy insert/removal of the device in the holder. Discreet design. With cig-plug cable.

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
 
The holder is equipped with a tilt swivel so you can easily adjust the angle of your device for better viewing. Tilts 17° and swivels 360°. Made of high grade ABS/Acetal plastic. Mounting plate 42x50 mm with AMPS-holes. Color: black. Made in Sweden. Attach onto a Pedestal Mount.


Also Suitable for:
For Kyocera DuraTR E4750 in all countries.


Installation Instructions

Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
 
2. To place the device in the holder: Place the lower part of the device in the lower part of the holder. Press/flip forward on the upper part of the device so it is properly in place in the holder.
 
3. To remove the device from the holder: Take support on the upper part of the holder, in the same time pull/flip the upper part of the device away from from the upper part of the holder. Lift the device straight upward out from the holder.
 
4. The holder is in place.

Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug