skip to main content

Brodit 2 part solution

Home > Brodit Step 1 > Datalogic > Falcon X3+ > Holders > Active holder for fixed installation

Active holder for fixed installation view larger image

Active holder for fixed installation for Datalogic Falcon X3+

With tilt swivel. Slim design with charger integrated in the holder.

For Datalogic Falcon X3+ in all countries. (Item # 532306)

£89.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

A bulk discount could be offered on any business order of 25+ pieces. For more details contact us.

The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior. The charging device is integrated in the holder itself, so there is no large charging box on the cable.

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended.

The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. The holder fits devices both with standard and extended battery. Attach onto ProClip Mounting Platform.


Also Suitable for:
For Datalogic Falcon X3 in all countries.
For Datalogic Falcon X3+ in all countries.
For Datalogic Falcon X4 in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: Route the cable from the holder into the vehicle dashboard and route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the botto part of the device into the holder. Slide the device downward into place in the holder. To remove the device fron the holder: Open the latch on the holder. Then the device is set frre, lift it upward out of the holder.

4. The holder is in place.

Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation